*THIS IS FOR THE PURCHASE OF DTF PRINTS THAT ARE PRINT READY*
IN ORDER TO PRINT A DESIGNERS FILE I MUST HAVE THE LICENSE TO DO SO. I BUY THOUSANDS OF DESIGNS A YEAR FROM ORIGINAL DESIGNERS AND HOLD ALL OF THE REQUIRED LICENSES.
**PLEASE NOTE THE DESIGNERS NAME IN THE TEXT BOX**
***IF YOU DO NOT PROVIDE THIS AND I KNOW WHO DESIGNED THE DESIGN I WILL REACH OUT TO THEM AND YOU WILL BE BANNED FROM ORDERING FROM ME AGAIN***
Custom File Requirements
Accepted File Formats
- PNG (strongly preferred — supports transparent backgrounds)
- PDF (high-resolution, vector or raster)
- PSD (flattened or with layers)
- SVG (vector files welcome)
- JPEG/JPG files are not recommended — they do not support transparency and may result in a white background on your transfer.
Resolution
- Minimum 300 DPI at print size. Higher is always better.
- Low-resolution or compressed files will not print clearly — please do not upscale a small file to meet resolution requirements.
Transparent Background
- All artwork should have a transparent background (no white or colored box behind the design) unless a background is intentionally part of your artwork.
- A white background in your file will print as white on the transfer.
Bleed & Margins
- Keep all important design elements at least 0.25" from the edge of your artwork canvas to avoid clipping.
- No bleed is required — DTF transfers are cut to the edge of your design.
Color Mode
- Please submit files in RGB color mode. DTF printing uses RGB-based inksets, and CMYK files may shift in color when converted.
Mirroring / Reversing Your Artwork
- Do NOT mirror or reverse your artwork before uploading. DTF transfers are applied face-down and the printing process handles orientation automatically — your design will press correctly as submitted.
DTF Print Heat Press Instructions
1. Pre-Press the Garment
- Lay the garment flat on a heat press mat (foam or silicone recommended for even pressure).
- Set your heat press to the same temperature, (320 degrees) you will use for the transfer.
- Press the garment for 5–6 seconds to remove moisture and wrinkles.
2. Apply the DTF Transfer (Initial Press)
- Place the cured PET film (printed and baked) with your design, white side down, onto the pre-pressed area of the garment.
- Ensure the entire design is within the heat press working area.
- Confirm your time and temperature settings are 320 degrees for 6 seconds
- Press
3. Peel the Film (Cool Peel)
- After the initial press, allow the garment and film to cool below 100°C (212°F), typically 10–20 seconds.
- Gently peel the PET film away from the design.
4. Re-Press for Durability (Highly Recommended)
- Place the garment (with the film removed) back on the heat press mat.
- Cover the printed image with butcher paper to prevent direct contact with the heat plate.
- Perform a complete secondary press cycle using the same parameters as the initial press.
- For large designs, reposition each corner and edge of the pattern at the center of the heat press and re-press each area to ensure strong edge adhesion.
5. Final Cooling & Storage
- Allow the garment to cool completely to room temperature.
- Store the finished garment in a sealed bag with a desiccant to protect from moisture.
6. Washing Guidelines
- Wait at least 24–48 hours after pressing before the first wash.
- Use mild, bleach-free detergent.
- Wash the garment inside out on a gentle cycle with water at room temperature or below 40°C.
- Avoid high-temperature drying and direct sunlight; air dry or use low-temperature drying.